If you desire me to do the installation, please call for an estimate. The amp MUST be in good working order. I do not do repairs. If you have a malfunctioning amp, have it repaired before shipping to me.

 
When sending your amp to have it modified, send me the chassis only, not the whole amp. Send it in a good quality box built to UPS standards. Please please PLEASE wrap it in bubblepack, double box it and fill the outer box so that there are at least 3 inches of peanuts all around the amp.

Box sizes
For a Nashville 400 use a 10 X 10 X 20 for the inner box and a 12 X 12 X 24 for the outer box.
For a Session 500 use a 6 X 10 X 25 for the inner boxes (one for each section) and a 18 X 18 X 30 for the outer box.

Disassembly Information
For Nashville 400 and Vegas 400 owners, to remove the chassis remove 4 screws holding on the back protection plate below the heat sink. Carefully wiggle and remove the white reverb connector located at the front of the amp near the speaker. Unhook the speaker leads. Unbolt the four screws at the top of the amp starting with the front screws and finishing with the one nearest the power transformer. Gently slide out the chassis and you're done!

For Session 500 owners, as you disassemble the unit be VERY careful to mark the connectors with a number both on the connector and the place it came from. Note the pointed end of each connector and trace around it on the circuit board with a permanent marker so that you will be able to get it back EXACTLY the way it came out. There are a LOT more screws and bolts to remove. Take your time and note where they came from.

 
Shipping Address
The address to ship your amp to is:

John LeMay
13206 North Classic Overlook Court
Tucson AZ 85737

 
Make the money order or cashiers check payable to John LeMay
Turn around is 4 - 5 days from when I receive it.

 
Call 520-825-7218
for further information